Router vulnerability note - DrayTek
DrayTek Vigor: the session parameter in an upload endpoint
What happened
The access-point configuration upload endpoint on the Vigor2960 and Vigor300B takes a
session value, and the value reaches a shell. The reporter published an exploit and DrayTek's release
notes for 1.5.1.5 carry the fix for the 2960, 300B and 3900 — a normal advisory cycle, honestly documented,
which is more than we can say for some vendors on this page.
CISA added it to KEV in May 2025, five months after disclosure. That is the pattern we watch for on DrayTek hardware specifically: the boxes sit at the edge of small businesses with a web interface that has, historically, been reachable from wherever the office IP was. If your Vigor still answers on the WAN and its firmware is from 2023, the exposure is not theoretical.
Who is affected
DrayTek Vigor2960 and Vigor300B on the 1.5.1.4-era firmware; the same component family covers the 3900.
Check it yourself
Version, and what can reach it
UI: System Status > Firmware Information
# Firmware Version : v1.5.1.4 (2024-08-15)
UI: Access Control > IP Filter / and: Administration > Router Access
$ curl -s -o /dev/null -w '%{http_code}\n' https://<wan-ip>/login.html
# a 200 there from a phone on mobile data is the whole answer
Do this
- Update to 1.5.1.5 or newer, from the release note that matches your model.
- If remote management must stay on, restrict it by source address rather than relying on obscurity.
- Check whether the access-point management features are used at all; if not, this endpoint is dead weight.
- Read the release notes: on Vigors, a point release sometimes changes the AP and VPN behaviour as well.
How we handle it
DrayTek's CLI is complete enough that we can do most of a visit from a telnet or SSH session through the tunnel. It is also the brand where we most often find an admin account shared with the installer three sites back.